MARINE GRADE ALUMABRITE CBX®
CLEANS, BRIGHTENS & PROTECTS RAW AND ANODIZED ALUMINUM
REMOVES WATER STAIN, OXIDE, SOOT, SOIL
LEAVES PROTECTIVE ALUMINUM OXIDE COATING
WILL NOT CORRODE ALUMINUM
ALUMABRITE CBX® may be applied hot or cold with high pressure sprayer, garden / pump sprayer or brush.
1. Use Full Strength for heavy build up. Dilute 1:1 with warm water for light build up. Test on inconspicuous area first, before applying to entire area. Brush off loose material if present. Remove marine fouling with ALGEX® and oily pollutants with BOAT CLEAN PLUS®, if present, following directions on the bottles. Aluminum must be dry, free of bio-fouling, oil and grease before applying ALUMABRITE CBX®, or streaking and blotching may occur..
2. Pour into plastic garden sprayer and spray ALUMABRITE CBX®, using a fine spray,from bottom to top and back down again making sure that the surface is completely drenched, without missing any spots. Keep Wet; DO NOT ALLOW TO DRY BEFORE RINSING. Wait 1 to 5 minutes until aluminum turns bright and rinse clean with fresh water using garden hose or pressure washer, before aluminum turns milky or white. Heavy build up may require additional applications. Works best at 70°F ± 15°F (21°C ± 9°C).
3. When clean and dry, protect aluminum with ALUMETRON® and VS721®.
DO NOT FREEZE
KEEP OUT OF REACH OF CHILDREN
MAY IRRITATE EYES. MAY IRRITATE SKIN. Do not get in eyes. Do not get on skin or clothing. Do not breathe fumes. Wear protective gloves/clothing and eye/face protection when mixing or using. Use only in a well-ventilated area.
If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 5 minutes. If on skin, rinse well with water. If on clothing, remove and wash clothing. Seek medical advice if discomfort or irritation persists